C-125

1. Purpose of the products

The containers are made of virgin polyethylene in accordance with TU U 25.2-33458437-003:

2007 POLYETHYLENE CONTAINERS.

The containers are reusable, used for STATIONARY

storage of liquid and loose products (including food and drinking water).

Polyethylene is resistant to UV radiation.

V60, V130, V200 containers have a tight lid, so they can be used

additionally used to transport liquid and loose products. Transportation only in

vertical position, without stacking, while the transport speed should not

exceed 60 km/h. When transporting partially filled containers

it is necessary to reduce speed on bends, ascents and descents.

ATTENTION!!! Tanks can be operated at temperatures from -30oС to +60oС,

if the temperature acting on them does not lead to chemical or physical damage

interaction of the stored substances with the material of the container, which may lead to

to destroy the container or change the chemical composition of the substance (e.g. destruction

container as a result of freezing of the substance, unsealing of the container, evaporation

liquids, etc.). These cases are not covered by the Manufacturer's Warranty.

Tanks are not designed to be installed in the ground.

2. Storage, loading, transport.

Tanks should be stored in the temperature range from -30oC to +60oC

flat, compact ground with an area that ensures its stable position. Conditions

storage should exclude the penetration of aggressive substances into the surface

tanks and the ingress of moisture inside the products. In the case of long-term

direct sunlight should be excluded during storage

products. The loading and unloading operation takes place with empty containers,

manually or with a forklift. The transport of empty containers is allowed

any type of transport with the required load capacity and dimensions of the platform

loading. The transport position of the tank must be agreed with the Manufacturer

Tanks must be secured, excluding the possibility of their movement

during the transport.

3. Installation and connection.

The tank should be installed on the flat surface that is intended

to the appropriate load (weight of the filled container). Deviations from the coating

horizontal in the longitudinal and transverse directions - not more than 3 mm per meter of length.

Permitted depressions and protuberances not exceeding 3 mm. Container

must be carefully inspected for defects before starting work

affect its operation. In case of detecting them, the Manufacturer should be informed

to eliminate defects. When installing on the foundation, check for correct

the location of the liquid inlet and outlet. When using V60, V130, V200 tanks to

when transported by road, it is necessary to fasten it

the tank with straps (not included in the delivery set) and ensure

stops that prevent the tank from shifting during movement.

The restrictors must be in contact with the tank through the damping pads which

prevent tank damage.

4. Use of containers in operation.

Before using the container for the first time, as well as after repeated use, the container

should be washed with a solution of baking soda with the addition of any detergent

disinfectant, then rinse with water. After the procedure - drain the water. All

the elements of the tank, including the cover, are not a load-bearing structure, therefore during

operation, it is forbidden to apply additional forces to the product